Installation Sheet

16
Turbo air
BASIC OPERATION
TSF-23SD-N
TSF-35SDN-N
TSF-49SD-N
TSF-72SD-N
TSF-23GSD-N
1. Plug in and turn on the power switch located on the bottom of the top grille right
side. The Display panel will be lighted and make a beep sound. The compressor will
begin to run.
2. The default temperature setting is No. “5”.
3. The compressor is automatically cycled by the electronic controller (PCB, F-Sensor).
4. The Defrost cycle is automatically controlled by the D-sensor, and the PCB.
5. Set level toward “1” for higher temperatures and toward “9” for lower temperatures.
6. The interior light is activated when the door is opened.
7. Evaporator fan motor(s) will run after all doors are completely closed.
8. Good Air Flow in freezer unit is critical.
Items loaded into the freezer should not be pressed against the back wall and items
should be kept 4inches away from the evaporator compartment.
FOR FREEZERS
FREEZERS