Turbo Air Speeds up the Pace of Innovation Worktop Refrigerators & Freezers Installation and Operation Manual `Please read this manual completely before attempting to install or operate this equipment Full Stainless Steel Visible Exterior REFRIGERATORS TWR-28SD TWR-36SD TWR-48SD TWR-60SD TWR-72SD FREEZERS TWF-28SD TWF-48SD TWF-60SD www.turboairinc.
CONTENTS PAGE SPECIFICATIONS 2 SERIAL NUMBER 2 INSTALLATION OF HANDLE 3 INSTALLATION OF CASTERS 3 HOW TO CLEAN THE PAN SUPPORTER 4 INSTALLATION 5 CLEANING 5 BASIC OPERATION 6 TROUBLESHOOTING 7 STAINLESS STEEL EQUIPMENT CARE AND CLEANING 8-9 WARRANTY 10-12 SPECIFICATIONS WORKTOP REFRIGERATORS MODEL COMP H.P. V/Hz REFRIGERANT AMPS WEIGHT TWR-28SD 1/4 115V/60Hz R-134A 6.6A 175lbs TWR-36SD 1/3 115V/60Hz R-134A 6.6A 198lbs TWR-48SD 1/3 115V/60Hz R-134A 6.
INSTALLATION OF CASTERS 1) Screw the caster (in rear side) and the caster brakes (in front side) by using caster wrench. 2) Use the caster shims to level the cabinet, if necessary, by inserting them to stems of the casters.
INSTALLATION OF DRAIN PAN 1) In damp season, when the drain water overflow the drain pan, remove the drain pan and pour the water away. And then set the drain pan back up as below drawing please (Model : TWR-28SD, TWF-28SD).
INSTALLATION 1. GOOD AIR CIRCULATION - Be sure to avoid any object which may stop the air flow - Be sure that there is ample air space so that air can flow through the rear of the unit - Turbo Air recommends that the rear of the unit be no less than 5 inches from the wall 2. PLACE ON STRONG GROUND - Be sure the location chosen has a strong enough floor to support the total weight of the cabinet and any other contents 3.
CAUTION 1. POWER CORD - Be sure the power cord is connected to the proper voltage - A protected circuit of the correct voltage and amperage must be run for connection of the line cord - Turn ʻoffʼ the power switch before disconnecting the power cord, whenever performing maintenance functions or cleaning the refrigerated cabinet - Compressor warranties are void if compressor burns out due to low voltage 2. RE-STARTING - If disconnected, wait 5 minutes before re-starting BASIC OPERATION 1.
TROUBLESHOOTING SYMPTOMS CAUSES SOLUTIONS Refrigerator(Freezer) is freezing(melting) food • The setting temperature is too low(high) to maintain food freshness. • Turn the temperature dial to a warmer(colder) setting. The unit does not refrigerate at all • There is a power connection failure problem. • Check the power cord to make sure the unit is pluged in it correctly. The unit does not refrigerate well • The unit is in sunlight or near a • Move out of sunlight or away heating device.
STAINLESS STEEL EQUIPMENT CARE AND CLEANING CAUTION : Do not use any steel wool, abrasive or chlorine based products to clean stainless steel surfaces. Stainless Steel Opponents There are three basic things which can break down your stainless steel’s passivity layer and allow corrosion to rear its ugly head. 1) Scratches from wire brushes, scrapers, and steel pads are just a few examples of items that can be abrasive to stainless steel’s surface. 2) Deposits left on your stainless steel can leave spots.
4. Water Treatment To reduce deposits, soften the hard water when possible. Installation of certain filters can remove corrosive and distasteful elements. Salts in a properly maintained water softener can be to your advantage. Contact a treatment specialist if you are not sure of the proper water treatment. 5. Maintaining the cleanliness of your food equipment Use cleaners at recommended strength (alkaline, alkaline chlorinated or non-chloride). Avoid build-up of hard stains by cleaning frequently.
MANUFACTURING COMPANY THREE YEAR WARRANTY Turbo Air warrants to the original purchaser of every new Turbo Air refrigerated unit, the cabinet and all parts thereof, to be free from defects in material or workmanship, under normal use and service, for a period of three (3) year from the date of original installation or 39 months after shipment date from Turbo Air , whichever occurs first.
Warranty Claims... All claims for parts or labor must be made directly thorough Turbo Air. All claims should include: model number of the unit, the serial number of the cabinet, proof of purchase, date of installation, and all pertinent information supporting the alleged defect. In case of compressor replacement under warranty, either compressor or compressor tag must be returned to Turbo Air along with above listed information. Failure to comply with warranty policies will result in voiding claims.
What is NOT covered by this warranty Turbo Airʼs sole obligation under this warranty is limited to either repair or replacement of parts, subject to the additional limitations below. This warranty neither assumes nor authorizes any person to assume obligations other than expressly covered by this warranty. 1. WARRANTY IS NOT TRANSFERABLE. This warranty is not assignable and applies only in favor of the original purchaser/user to whom delivered.
