Residential Single and Double Wall Oven Service Manual

A.8 APPENDIX  REPLACING OVEN COMPONENTS
Component and Assembly Location, SWO
DANGER: Before removing or replacing any oven component, ensure the oven is removed from any
power source (i.e., the breaker is turned off ). Failure to do so can result in serious injury or death.
WARNING: Before removing or replacing any oven component, thoroughly read the safety instructions
found at the front of this manual and in Oven Systems (Section 5) and Troubleshooting (Section 6). Adhere to
all precautions and warnings outlined in these sections, as failure to do so could result in serious injury or death.
CAUTION: Before removing/installing any component, make sure it is disconnected from the wire
harness (where applicable).
Removing the Oven
In order to remove the oven from the wall, the two mounting screws (P/N: 104184), located on the inside of
the Speedcook oven’s outer trim, must be removed.  e oven may be safely pulled away from the wall
approximately 11” (280 mm) to remove the front top cover, lower EC access panel, and the door switch
covers. Any further removal requires the oven to be fully removed from the wall and placed upon a cart
capable of supporting approximately 230 lbs. (105 kg.).
Item Description Item Part # Hardware Description Hardware Part Number(s)
Air Switch 102009 Screw, 4-40 x 5/8, PPH, SS 101550 (x2)
Blower, Exhaust 104190 Screw, SH MTL, #8 x 1/2 Serrated PHTRH 101688 (x2)
Cover, Back, SWO RWS-9018 Screw, SH MTL, #8 x 1/2 Serrated PHTRH 101688 (x11)
Door Skin, Replacement RWD-3004-X None None
Door, Speedcook Oven RWD-3019-X
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Cover, Hinge Pocket
Screw, #8-32 x 3/8, PPH, THD-Forming, PLT
101688 (x4)
RWD-9472 (x2)
104227 (x2)
Door, Speedcook Oven, Inner RWD-3022 None None
Electrical Compartment, SWO
(see pages A.16-A.17)
N/A None None
Front Trim, SWO
(see pages A.10-A.11)
N/A
Screw, #8 x 3/8 PH MOD TRUSS CRES
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Screw, #8 x 2.00 PH MOD TRUSS SS
101682 (x16)
101688 (x4)
104184 (x2)
Handle, Speedcook Oven RWD-9011 Bolt, Handle, Speedcook Oven RWD-9458 (x2)
Harness, Single RWS-9002 None None
Oven, Speedcook, SWO
(see pages -A.25)
N/A None None
Thermostat, 270F, Open on Rise 104228 Screw, #6 x 1/2, PPHD, DRL-PT, SS 101687 (x2)
Top Cover, Front RWD-9356 Screw, SH MTL, #8 x 1/2 Serrated PHTRH 101688 (x7)
Top Cover, Rear RWD-9355 Screw, SH MTL, #8 x 1/2 Serrated PHTRH 101688 (x11)
USB Port, Gen 2 103193
Screw, SH MTL, #8 x 1/2 Serrated PHTRH
Bracket, USB, Strap
101688 (x2)
RWS-9026