Installation Instructions

For complete and up-to-date installation and warranty information please visit www.turboclipusa.com
Start at the end of the deck away from the house. First, place the TurboClip® Starter Clip on the joist 1/4” from the outside
edge of the deck frame. Align the screw with the center of the perpendicular joist and secure. Continue across the length of
the deck frame using one (1) Starter clip at every cross joist. Be sure to align the starter clips so that the deck boards are
installed level across the lineal path.
Push the first deck board into the starter clip.
Insert TurboClip® Hidden Deck Clip into the side groove of the board. The arrow on each clip indicates which side to
insert. Align the screw with the center of the joist. Drive the screw so that the head is flush with the clip. DO NOT
OVERDRIVE SCREW. Overdriving screws will cause clip failure. Pull up, twist and snap off the remaining TurboClip® stick.
Slide the next deck board into place. Continue across the length of the deck board. Continue to measure the distance to
home and adjust accordingly so the last board doesn’t have to be trimmed lengthwise at an angle.