User's Manual

Section Ten - Specifications

Modulation std.: K56flex

™

**, V.34, V.32bis, V.32, V.29, V.27ter, V.22bis,

V.23,V.22, V.21, V.17, Bell212/103

Compression: V.42bis, MNP Class 5

Error Correction: V.42, MNP Class 2-4

Host Interface: ISA 16 bit bus

COM ports: 1, 2, 3, 4

IRQ lines: 2, 3, 4, 5, 7*, 10*, 11*, 12*

FAX Group: Group III

FAX Command: EIA/TIA 578 class 1

VOICE Command: Rockwell (Optional)

Transmit level: -10 dBm +/- 1 dB

Sensitivity: -43 dBm

UART: 16550 compatible

Power: .75 W max

Temperature: 0 to 55 degrees C, operating; -20 to 80 degrees C, non-

operating

Note: *

IRQ7, IRQ10, IRQ11 and IRQ 12 are support

for Plug and Play

model only

Section Eleven - FCC and DOC Notices

11.1 FCC Compliance

This equipment complies with Part 68 of the FCC Rules. On this equipment

is a label that contains, among other information, the FCC registration

number and Ringer Equivalence Number (REN) for this equipment. You

must, upon request, provide this information to your telephone company.

If your telephone equipment causes harm to the telephone network, the

Telephone Company may discontinue your service temporarily. If pos-

sible, they will notify in advance. But, if advance notice isn't practical, you

will be notified as soon as possible. You will be informed of your right to file

a complaint with the FCC.

Your telephone company may make changes in its facilities, equipment,

operations, or procedures that could affect proper operation of your

equipment. If they do, you will be notified in advance to give you an

opportunity to maintain uninterrupted telephone service.

The FCC prohibits this equipment to be connected to party lines or coin-

telephone service.

In the event that this equipment should fail to operate properly, disconnect