User's Manual

Heritage Series ADSL Bridge/ Router

Network Set-Up

2.2 Network installation

1. Connect the power adaptor to the power jack that marked

Power

at the rear panel of the Router, then plug in the AC power

adaptor to the wall electrical outlet.

2. Connect the LAN cable.

Connect one end of 10Base-T Ethernet cable (straight through

or crossover) to the LAN ports on the rear panel, and then

connect the other end of 10Base-T Ethernet cable to PCs, HUB

or other network device.

3. Connect the WAN cable.

Connect one end of 10Base-T Ethernet straight through cable

to the WAN port on the rear panel, and then connect the other

end of 10Base-T Ethernet cable to Cable Modem, ADSL or

corporate network.

MSO/NSP

Broadband Sharing Router

Dumb HUB or switch HUB(s)

Internet

Straight Ethernet Cable

Straight or

crossover

Ethernet

Cable

Cable Modem/ADSL/

Corporate Network

Network configurating diagram