User's Manual

Heritage Series ADSL Bridge/ Router
A11
Appendix
C.2 No respond or active data
!"
No respond from system configuration server
- Make sure your URL is correct and not conflict with any other
device on network. The factory default URL is
“http://192.168.100.1 “. You cannot recall any page or
budirectory without password verification. Please do not add
any parameter after the IP address. If you changed the LAN IP
address, please use the new system configuration server IP you
changed. If you forget the IP you changed, you can only reset
the configuration to factory default to setup your Router again.
Please refer
3.1 Get your Broadband Sharing Router ready
to
know how to reset the Router configuration to factory default.
- Make sure you are accessing the configuration server through
LAN ports. The configuration server can only be accessed
through LAN ports, not from WAN port.
- Make sure your configuration PC is in the same subnet which
LAN port setup specified or your IP is getting from Router
DHCP. Please use IP configuration check to verify your PC’s IP
address.
- Make sure your LAN port connection is linked and active
correctly.
!"
Data link is brocken
- If your network is configured correctly, you can share and
connect different computers. If the data cannot be accesses
through the Router, restart your Router with unplug the power
cord. Wait for a while and plug in the power again. The system
needs one to two minutes to boot itself up. Please wait until the
PWR/CHK LED light steadly and then keep going for further
operation.
- Make sure that all devices IPs connected with LAN port, direct
connect or through HUBs, should follow the rule of LAN port
configuration. Gateway IP is the same as system configuration
server and cannot be used by any other device.