How to Guide

10 TurboLock TL111 PRO
3.2 Main Installation
Step 1. Start with the Outside Knob. Feed the power cable and tail piece through the square hole in latch. Thread the two pegs
through the smaller, round holes. If needed, have someone hold the door itself or hold the Outside Knob at against
the front of the door afterwards. (Fig. 4)
Do NOT force the cable’s connector end through any part of the lock. Damaging the connector may make the lock
unusable.
It’s highly recommended to leave the door open during installation.
Step 2. Align the back plate on the back of the door to make sure the slot is upward, and feed the power cable through the
center hole of back plate. Use the 2x mounting screws to fasten the back plate to the door. Make sure both screws are
tightened. (Fig. 5)
Step 3. Feed the power cable through the back plate cover, and cover it on the back plate part, then use the hex key to fasten
the inside screw at the bottom of back plate cover. (Fig. 6)
Tail Piece
(Fig. 4) (Fig. 5)
2 x Mounting Screws
Slot is upward
Back Plate
(Fig. 6)
Inside Screw
Power Cable
Back Plate Cover