How to Guide

16 TurboLock TL111 PRO
Step 8. Position the strike and strike box, then use a pencil to mark the center points
of the screw openings in the strike plate. Set the strike and strike box aside
and drill two small holes at each center point.
Step 9. Position the strike and strike box. Add the two remaining Wood Screws and
use a screwdriver (not included) to secure them.
4.2 Main Installation
Step 1. Start with the Outside Knob. Feed the power cable and tail piece through the square
hole in the latch and thread the two pegs through the smaller, round holes. If needed,
have someone hold the door itself or hold the Outside Knob at against the front of
the door. (Fig. 18)
Do NOT force the cable’s connector end through any part of the lock. Damaging the
connector may make the lock unusable.
It’s highly recommended to leave the door open during installation.
Step 2. Align the back plate on the back of the door to make sure the slot is upward, and
feed the power cable through the center hole of back plate. Use the 2x mounting
screws to fasten the back plate to the door. Make sure both screws are tightened.
(Fig. 19)
Tail Piece
(Fig. 18)
(Fig. 19)
2 x Mounting Screws
Slot is upward
Back Plate