How to Guide

TurboLock TL111 PRO 17
Step 3. Feed the power cable through the back plate cover, and cover it on the back plate
part, then use the hex key to fasten the inside screw at the bottom of back plate
cover. (Fig. 20)
Step 4. Feed the power cable through the battery compartment and make sure the side
with inside screw is downward. (Fig. 21)
Step 5. Gently pull the power cable out to snap it into the cable connectors, then collect the
cable back to battery compartment. (Fig. 22)
Step 6. Install 4 x AAA standard batteries into battery compartment. Cover the inside knob
over battery compartment and make sure the side with inside screw is downward. Use the hex key to fasten the inside
screw to complete the installation. (Fig. 23)
Hex Key
Power Cable
(Fig. 21)
Power Cable
(Fig. 22)
4 x AAA Batteries
Inside Knob
Hex Key
(Fig. 23)
Do NOT force the cable’s connector end through any part of the lock. Damaging the connector may make the lock
unusable.
Step 7. The lock should now be ready to use. It’s highly recommended to use the default password to test the lock to
make sure it works before closing the door. See Section 6 for information on the default admin password.
(Fig. 20)
Inside Screw
Power Cable
Back Plate Cover