Manualshelf

User Manual

ManualsBrandsTurbosmart ManualsCarBOOST CONTROLLERS - In-Cabin
1234
1
------------------------------------------------------------------------------------------------------------------------
ABOUT THIS PRODUCT
Thank you for purchasing your new Turbosmart Incabin boost controller (ICBC). This new model now has some great new features.
These include:
• 2 ramp rates of boost to give you the option of a fast rise in boost or a slightly tame rise for more sensitive setups.
• A wider boost adjustment range for wastegates with low spring base pressures.
• A new mounting bracket to make it easier to mount.
IMPORTANT NOTES ON YOUR BOOST CONTROLLER
• Use only silicone hose that is the correct size and pressure rating for your application when fitting your boost controller – other
hoses will be affected by heat and will eventually crack or split which could cause excessive boost pressure and engine damage
• Ensure that all plumbing is secured with clamps
• The ICBC connecting hose should be adequately shielded from heat and positioned at least 200mm from the turbine housing or the
exhaust manifold
• A Turbosmart Fuel Cut Defender may need to be used in conjunction with your boost controller – refer to www.turbosmart.com.au
• The boost dial has a left handed thread, be sure not to over tighten as this will damage the boost controller
RECOMMENDATIONS
• Turbosmart recommends that the Air Fuel ratio is checked once boost pressure is set
• Turbosmart recommends that boost pressure is set using a Dynamometer and not on the street
• Turbosmart recommends that a accurate boost gauge be permanently fitted to the vehicle
• Turbosmart recommends that your boost controller is fitted and adjusted by an appropriately qualified technician
------------------------------------------------------------------------------------------------------------------------
HOW TO INSTALL YOUR BOOST CONTROLLER
TOOLS REQUIRED
General mechanic tools
1) INTERNAL WASTEGATE SETUP
1. Allow the engine to cool down before installing your boost controller
2. Locate the pressure source port and the wastegate actuator port on the turbocharger assembly (refer drawing 1)
3. Remove the factory boost control solenoid if fitted from the boost pressure supply port while leaving the solenoid connected to
the ECU
4. Install the tee piece in the wastegate pressure line with the wastegate arrow pointing towards the wastegate actuator and run
the tee piece pressure line into the cabin and connect it to the bottom port of the boost controller
5. Run a second pressure hose line from the engine bay into the cabin and connect it to the top vent port
6. If your wastegate actuator has additional ports, these will need to be blocked
7. Secure all silicone hose ends with hose clamps
8. Mount your boost controller bracket inside the vehicle cabin, then attach the boost controller onto the bracket with the
supplied screws
9. Make sure the boost dial is turned completely anti-clockwise before making adjustments.
Product Name: Incabin Boost Controller
Product Description: Manual Boost Controller
Product Number: TS-0106-1001
Wastegate actuator port
Tee Piece
Pressure source port
(Located before the
throttle body)
Compressor
Boost dial
Wastegate Arrow
Vent into engine bay

Summary of content (4 pages)