User Manual

www.TURBOSMARTONLINE.com
5
10) Slowly push the top cap down on the lower diaphragm housing in a vice or press. As the cap reaches the diaphragm, slowly
turn the cap left and right as you lower the cap to the lower diaphragm housing. Make sure that the convolution of the
diaphragm is not pinched between the top cap and the lower diaphragm housing. Refit the upper wastegate cap re-
using the M6 Socket head cap screws. Again you may find it helpful to use a press to hold down the cap with a press or a
clamp while tightening these screws. Tighten the M6 Socket head cap screws using a 5mm Allen Key and torque to 8 N-m
(5.9 lb-ft)