iQ SERIES 2500 Watt 2 Way 8"/10"/12"/15" Powered Loudspeaker 3000 Watt 15"/18" Powered Subwoofer KLARK TEKNIK DSP Technology, Speaker Modelling and ULTRANET Networking
iQ series Important Safety Instructions Terminals marked with this symbol carry electrical current of sufficient magnitude to constitute risk of electric shock. Use only high-quality commercially-available speaker cables with plugs pre-installed. All other installation or modification should be performed only by qualified personnel. This symbol, wherever it appears, alerts you to the presence of uninsulated dangerous voltage inside the enclosure voltage that may be sufficient to constitute a risk of shock.
4 iQ series Quick Start Guide 6. Nettoyez l’appareil avec un chiffon sec. Consignes de sécurité Les points repérés par ce symbole portent une tension électrique suffisante pour constituer un risque d’électrocution. Utilisez uniquement des câbles d’enceintes de haute qualité disponibles dans les points de vente avec les connecteurs Jack mono 6,35 mm déjà installés. Toute autre installation ou modification doit être effectuée uniquement par un personnel qualifié.
6 iQ series Instruções de Segurança Importantes Aviso! Terminais marcados com o símbolo carregam corrente elétrica de magnitude suficiente para constituir um risco de choque elétrico. Use apenas cabos de alto-falantes comercialmente disponíveis de alta qualidade com plugues TS de ¼" pré-instalados. Todas as outras instalações e modificações devem ser efetuadas por pessoas qualificadas.
8 iQ series ᧙ᄋ߸Мᮍᅽ ࣝధ൦ಗᄋጽቬܭЧధृ ܹᄋႄุ ߜڛᝐႄԁᬘǎ ̪ᬎ Ώၺࣝధ ¼" TS ੌ੶ᩛऱତ݁ ᄋᰵַ᠐˅ˋੵܧ٩ጴǎ ధᄋ߸ᜊੌួ ڪᮍႁՍಬᄋ˅ˋ̢ցᤊᛢǎ ൦ಗଣᧉ১ ַ̘аߜڛఴ ፑᎇᄋԁᬘႄԎ ధᝐႄԁᬘǎ ൦ಗଣᧉ১ಋᬅᄋ᧙ ᄋΏၺԤ፦οឮǎ ឱ឵ధ Угǎ ࠶ॸ ˟ᥙГᝐႄԁᬘ ឱӉ੫ऩ఼ ᮈᄧ ੌᑁ᭨ౝ ǎ ܭа෦ ధԼΚၺਜ਼፦οΏၺᄋᦋ͉ǎ ឱ࠳፦ο̄ ᮋ̕ႁՍಬᄋ˅ˋ̢ցᤊᛢǎ Quick Start Guide 11. ឱԷΏၺԉࠓࠁᄋᬅ͉ᦢ֘ܭǎ 12. ឱԷΏၺԉࠓ ࠁᄋੌᬥ᠏ᩚ ᄋଏᢽ ౷ߖ ʽᝉ౷ ౷֘ಹ ߖǎ ᔫΏၺଏᢽ ୄᤃ ܭឱญ ਔ߸МᎷ ܭ ̀ᥙГଏᢽ֘ ܭϛωᏬԫ͟ǎ 13. ᥆᫆ႄᭈᲟੌ᫃ఱˁΏၺశܭ ឱ ફѤႄ຺ତ݁ǎ 14.
10 iQ series Quick Start Guide (1) LCD SCREEN displays the current DSP module and parameter settings. Networking capability (2) SETUP button steps through parameters within DSP processing modules. All iQ powered loudspeakers offer remote control via USB. The USB connection allows the user to (3) PROCESS button steps through the DSP processing modules. (4) SIGNAL LED lights up to indicate the channel is receiving a signal. (5) GAIN controls adjusts the analogue input level.
12 iQ series Networked mains power Quick Start Guide iQ DSP Menu Structure iQ loudspeakers also facilitate networked transmission of mains power using power cables with Fullrange Subwoofer Neutrik powerCON locking power connectors. To set up networked mains power between iQ loudspeakers, first run a power cable terminating in a powerCON connector to the AC INPUT connector on the rear panel.
14 iQ series Quick Start Guide Fullrange Subwoofer Function Auto Auto Automatically sets as many filters as required. Whenever a new feedback frequency is discovered, the first filter will be released to attenuate the new frequency, and so forth. Single Single Activates the FBQ (feedback detection) functionality, up to 8 feedback filters. FBQ Automatic procedure which searches for feedback frequencies and locks settings after all 8 filters have been set.
16 iQ series Quick Start Guide 17 Pole Mounting Mounting and fixing iQ series powered loudspeakers are designed with multiple internal rigging points to suit many possible mounting methods in permanent installations. All cabinets can be simply suspended using optional M10 eyebolts coupled to the internal rigging points provided on the top, bottom, sides and back.
iQ series 18 Quick Start Guide 19 Technical Specifications iQ8 iQ10 iQ12 System Frequency response 60 Hz – 18 kHz ±3 dB 55 Hz – 20 kHz -10 dB 55 Hz – 18 kHz ±3 dB 50 Hz – 20 kHz -10 dB 52 Hz – 18 kHz ±3 dB 45 Hz – 20 kHz -10 dB Nominal dispersion 90° H x 90° V @ -6 dB points 90° H x 60° V @ -6 dB points 80° H x 60° V @ -6 dB points Maximum SPL 128 dB peak 129 dB peak 130 dB peak Crossover type Active Active Active Transducers 1 x 8" (208 mm) LF driver 1 x 1" (25.
iQ series 20 Quick Start Guide 21 Technical Specifications iQ15 iQ15B iQ18B System Frequency response 50 Hz – 18 kHz ±3 dB 42 Hz – 20 kHz -10 dB 50 Hz – 130 Hz ±3 dB 40 Hz – 130 Hz -10 dB 50 Hz – 100 Hz ±3 dB 36 Hz – 100 Hz -10 dB Nominal dispersion 75° H x 55° V @ -6 dB points Half Space Half Space Maximum SPL 132 dB peak 130 dB peak 132 dB peak Crossover type Active Active Active Transducers 1 x 1" (387 mm) LF driver 1 x 1" (25.4 mm) HF compression driver 1 x 15" (385.
22 iQ series Other important information Important information 1. Register online. Please register your new MUSIC Group equipment right after you purchase it by visiting turbosound. com. Registering your purchase using our simple online form helps us to process your repair claims more quickly and efficiently. Also, read the terms and conditions of our warranty, if applicable. 2. Malfunction.
