Quick Start Guide

34 Milan Series Quick Start Guide 35
Milan Series Controls
(1) (2) (3)
(5)
(12)
(5)(6)
(4)
(4)
(10)
(11)
(9)
(7)(8)
(1) Mains Connector – Mainspower is
connected to the subwoofer via an
IECconnector.
(2) Fuseholder – Replace fuse only with the
same type andrating.
(3) Mains Switch – Toggle push switch turns
mains power on to the loudspeaker. Make
sure the level control is fully o (MIN) before
switching on.
(4) Inputs – These combo female XLR/jack
connectors accept both 3-pin XLR connectors
and mono (2 pole) orstereo (3 pole) ¼"
jack plugs for connection to balanced or
unbalanced mixing consoleoutputs.
(5) Thru Connections – These3-pin balanced
male XLR connectors provide independent
full range audio signals from each input
channel for loop-through connections to
Milan two-way loudspeakers or additional
Milan subwoofers.
(6) Boost – Applies +6 dB of boost with a
Q factor of 1 at a centre frequency selected via
the associated boost freq control (12).
(7) Limit Indicator – Illuminates red when the
signal level approaches maximum and the
limiters start working.
(8) Signal Indicator – Illuminatesgreen to
indicate that input signal is present.
(9) Power On Indicator – BlueLED
illuminates when mains power is applied
to the subwoofer and powered up via the
rockerswitch.
(10) Polarity – Reverses the polarity of the
subwoofer relative to the two-way Milan
loudspeakers connected to the thru outputs.
(11) Level Control – Rotary level control which
attenuates the input signal level of the
subwoofer and (line) from -∞(MIN) to
+43 dB (MAX).
(12) Boost Freq – Selects the centre frequency at
which the boost is applied, and is continuously
variable from 40Hzto90Hz.