Rigging Manual
Table Of Contents
- (EN) Safety Instruction
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling an MV212 Array on a MAN-FG Fly Grid
- Chapter 4: Assembling MS215 Subwoofers on a MAN-FG Fly Grid
- Chapter 5: Assembling an MV212 Array with a MS215 Subwoofer
- Chapter 6: Groundstack of two MS215 Subwoofers
- Chapter 7: Groundstack MS215 Subwoofer and MV212 Array
- Chapter 8: MV212-VT and MS215-VT Vertical Transporters
- Chapter 9: Safety Inspection
- Chapter 10: Enclosure quantities and combinations for MAN-FG fly grid suspension at 10:1, 7:1, and 5:1 design factors
14 MANCHESTER SERIES Rigging Manual
2.3 MV212 Cabinet Angles
The angle of each MV212 cabinet relative to the cabinet above it, is varied by inserting the quick release pin into one of the mounting holes in the rear mounting
bracket. These are labeled from 0 to 10 degrees.
Use the “STOW” position to securely stow the sliding mount plate in the lowest position when not in use.
The Zero degrees position uses the same hole as “STOW” but is used with the sliding mount plate moved up to its highest postion. (The plate is captive,
and will not fall out.)
6 degrees
0 degrees
1.5 degrees
STOW position
or zero degrees
1 or 5 degrees
0.5 or 4 degrees