Rigging Manual
Table Of Contents
- (EN) Safety Instruction
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling an MV212 Array on a MAN-FG Fly Grid
- Chapter 4: Assembling MS215 Subwoofers on a MAN-FG Fly Grid
- Chapter 5: Assembling an MV212 Array with a MS215 Subwoofer
- Chapter 6: Groundstack of two MS215 Subwoofers
- Chapter 7: Groundstack MS215 Subwoofer and MV212 Array
- Chapter 8: MV212-VT and MS215-VT Vertical Transporters
- Chapter 9: Safety Inspection
- Chapter 10: Enclosure quantities and combinations for MAN-FG fly grid suspension at 10:1, 7:1, and 5:1 design factors
45 MANCHESTER SERIES Rigging Manual
6
7
9
12
11
10
10
10. Prepare the next MV212 cabinet, by pulling out the front lower rigging pins
(6), and the rear lower rigging pin (7). (See step 5.)
11. Carefully lift the MV212 cabinet until its lower front mounting slots ๎t over
the links (10) of the lower MV212. Reinsert the front pins (6) to secure the
links (10) to the lower MV212.
Take care not to trap your ๎ngers between components.
12. Align the upper MV212 cabinet's rear lower mounting hole with the top hole
in the lower MV212's rear mounting plate (11). Reinsert the rear pin (7) to
secure the rear of the upper MV212 to the rear mounting plate of the lower
MV212.
Double check that all pins are correctly inserted,
before proceeding further.
13. The addition of other MV212 cabinets is performed by repeating procedure
steps 8 through 12 for each additional cabinet.
Double check all the connections to make sure that the
MS215 subwoofer and MV212 cabinets are all securely
connected together.
โ! WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 6 MV212 CABINETS FOR THIS GROUNDSTACK
CONFIGURATION. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE PERMANENT
INJURY OR DEATH.
NOTE
Disassembly is the reverse of assembly.