Rigging Manual
Table Of Contents
- (EN) Safety Instruction
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling an MV212 Array on a MAN-FG Fly Grid
- Chapter 4: Assembling MS215 Subwoofers on a MAN-FG Fly Grid
- Chapter 5: Assembling an MV212 Array with a MS215 Subwoofer
- Chapter 6: Groundstack of two MS215 Subwoofers
- Chapter 7: Groundstack MS215 Subwoofer and MV212 Array
- Chapter 8: MV212-VT and MS215-VT Vertical Transporters
- Chapter 9: Safety Inspection
- Chapter 10: Enclosure quantities and combinations for MAN-FG fly grid suspension at 10:1, 7:1, and 5:1 design factors
47 MANCHESTER SERIES Rigging Manual
3
3
1
2
4
9
9
5
6
6
8
7
10
1. Prepare the rst MV212 cabinet, by pulling out the front lower rigging pins
(1), and the rear lower rigging pin (2).
2. Carefully lift the MV212 cabinet until its lower front mounting slots t over
the 2 front mounting links (3) of the MV212-VT. Reinsert the front pins (1) to
secure the MV212-VT mounting links (3) to the MV212.
Take care not to trap your ngers between components.
3. Align the MV212 cabinet's rear lower mounting hole with the top hole in the
MV212-VT rear mounting link (4). Reinsert the rear pin (2) to secure the rear
of the MV212 to the MV212-VT rear mounting link.
Double check that all pins are correctly inserted,
before proceeding further.
4. Other MV212 cabinets can be added to the rst cabinet, using the same
procedure as shown in the section on ground stacking.
Make sure the angles are all set at zero degrees as indicated by
the angle markings on the rear mounting plate of each MV212.
5. When the last cabinet has been added, the top lid of the MV212-VT can be
added as follows, to protect the cabinets.
6. Prepare the top MV212 cabinet for attaching the top lid of the MV212-VT, by
pulling out the 2 front upper rigging pins (5). The spring-loaded top links (6)
will move to the up position. Reinsert the pins (5) to secure the links (6) in
the up position.
7. Pull out the rear upper rigging pin (7), and slide the MV212's rear mounting
plate (8) upwards and reinsert the rigging pin (7) into the zero degrees hole.
8. Pull out the rigging pins (9 and 10) from the top lid of the MV212-VT.
9. Lower the top lid onto the top of the upper MV212 cabinet and carefully align
it so the mounting positions in the top lid t over the MV212 top links (6) and
the rear mounting plate (8).
10. Reinsert the front pins (9) to secure the front links (6) to the top lid. Reinsert
the rear pin (10) to secure the rear mounting plate (8) to the top lid.
Double check that all pins are correctly inserted.
! WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 4 MV212 CABINETS FOR EACH MV212-VT.
FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE PERMANENT INJURY OR DEATH.
8.1 Attaching MV212 cabinets to the MV212-VT