Rigging Manual
Table Of Contents
- (EN) Safety Instruction
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling an MV212 Array on a MAN-FG Fly Grid
- Chapter 4: Assembling MS215 Subwoofers on a MAN-FG Fly Grid
- Chapter 5: Assembling an MV212 Array with a MS215 Subwoofer
- Chapter 6: Groundstack of two MS215 Subwoofers
- Chapter 7: Groundstack MS215 Subwoofer and MV212 Array
- Chapter 8: MV212-VT and MS215-VT Vertical Transporters
- Chapter 9: Safety Inspection
- Chapter 10: Enclosure quantities and combinations for MAN-FG fly grid suspension at 10:1, 7:1, and 5:1 design factors
26 MANCHESTER SERIES Rigging Manual
2.17 MAN-FG Fly Grid Mounting Components
Tip Bar
Single Point Shackle Plate
MV212 ground stack angle plate
1
5
3
2
11
8
Front
Front
Front
Front
9
5
4
10
7
7
6
4
The MAN-FG y grid shall only be used with MV212 cabinets and MS215
subwoofers. It is not designed to work with any other cabinets.
1. Mounting Links – These retractable links connect the y grid to
the bottom mounting slots of an MV212 cabinet or MS215 subwoofer.
The connections are secured using the lower pins of the MV212 cabinet or
MS215 subwoofer.
2. Rigging Pins – These are used to secure the mounting links (1) in the up or
down positions.
3. Tip Bar – This has 23 20 mm diameter holes that are used to attach
bow shackles or similar lifting equipment for suspending the assembly.
Use the EASE FOCUS software to determine the correct pick points
for each conguration. The bar is tted to the y grid using four quick
release pins, and all must be securely tted and inspected before ying.
4. Ground Stack Angle Plate – For attaching the y grid to the rear lower
mounting point of an MV212 for ground stacking. The plate is attached to
the y grid with two pins, after the Tip bar (3) is removed. The MV212 has
one pin for attaching the top hole of this plate to the rear mounting hole of
the MV212.
5. Single Point Shackle Plate – This has one 20 mm diameter hole that is
used to attach a bow shackle or similar lifting equipment for suspending the
assembly. Use the EASE FOCUS software to determine the correct pick point
for each conguration. The shackle plate is tted to the y grid using two
quick release pins, after the Tip bar (3) is removed.
6. Mounting Links – These welded links have 22 mm diameter holes that are
used to secure secondary safeties to the y grid.
7. Lower pins – These pins secure the y grid to the top mounting links
of the MV212 cabinet or MS215 subwoofer. Use all 4 when securing an
MS215 subwoofer. Use the front 2 pins and rear pin (9) when securing an
MV212 cabinet.
8. Mounting Slots – The top mounting links of the MV212 cabinet or MS215
subwoofer t into these slots and are secured together with the pins (7).
9. Rear Pin – This pin is used to secure an MV212 rear mounting plate when
ying an MV212 or MV212 array.
10. Handle– The y grid is tted with a carrying handle.
11. Front Bracket– This laser bracket is used for precise aiming of the array
using user-supplied industry standard inclinometer devices.