Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
14 TBV123 / TBV123-AN and TBV118L / TBV118L-AN Rigging Manual
2.9.2 Typical Locations where Rigging Pins are used
GAP !
Pins correctly inserted, all the way in
Pins correctly inserted, all the way in,
and arm clipped in place
WARNING
VERIFY THAT EACH PIN IS CORRECTLY INSERTED, AND THAT EACH PIN CANNOT BE PULLED OUT WITHOUT
PRESSING THE RELEASE BUTTON FIRST. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE PERMANENT
INJURY OR DEATH.
Pins incorrectly inserted (Not inserted fully, spring
balls are not visible, and arm not clipped in place)