Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
20 TBV123 / TBV123-AN and TBV118L / TBV118L-AN Rigging Manual
4. Remove the captive rigging pins (3) on the TBV123-FB.
5. Align the holes in the ends of the ybar arms with the corresponding holes
in the TBV123 cabinet’s mounting links (1). Insert the ybar’s 2 rigging pins
(3) to secure the mounting links and the ybar together.
Double check that both pins are correctly inserted,
before proceeding further.
3
1
3
1
1. Assemble the ybar as shown on page 18.
2. Remove the rigging pins (2) from the TBV123 cabinet and lift up the 2
mounting links (1). Place the rigging pins back into their storage positions.
3. Lift the assembled TBV123-FB ybar into position above the prepared
TBV123 cabinet.
Take care not to trap your ngers between components.
2
1
1
3
3
3
3
Procedure 3.1 Attaching a TBV123 Cabinet to the TBV123-FB Flybar