Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
Rigging Manual 23
Procedure 4.1 Assembling a TBV118L Array on a TBV123-FB Flybar
1. Prepare the TBV118L subwoofer, by removing the rigging pins (2) and lifting
the mounting links (1) to the upwards position.
2. Lift the assembled TBV123-FB ybar into position above the prepared
TBV118L subwoofer.
Take care not to trap your ngers between components.
3. Remove the captive rigging pins (3) on the TBV123-FB and place the TBV118L
rigging pins (2) back in their storage position on the top enclosure.
4. Align the holes in the ends of the ybar arms with the corresponding holes
in the TBV118L subwoofer's mounting links (1). Insert the two, captive ybar
rigging pins (3) to secure the mounting links and the ybar together.
Double check that both pins are correctly inserted,
before proceeding further.
3
1
3
1
1
2
3
3