Rigging Manual

24 TBV123 / TBV123-AN and TBV118L / TBV118L-AN Rigging Manual
5. If you are ying just one TBV118L subwoofer, then this completes the
assembly procedure. To add another TBV118L subwoofer, continue with the
procedure steps below.
6. Attach the bow shackle or other lifting equipment securely to the ybar
mounting hole recommended by the EASE FOCUS II software, then attach
the hook and chain.
7. Prepare the next TBV118L subwoofer, by removing the rigging pins (2) and
lifting the mounting links (1) to the upwards position.
8. Carefully position the ybar/rst subwoofer assembly until it is on top of the
prepared lower subwoofer (with its mounting links (1) up). The feet of the
top subwoofer should t into the recesses on top of the lower subwoofer.
Take care not to trap your ngers between components.
9. Adjust the position of the mounting links (1) of the lower subwoofer to align
with the lower mounting holes of the upper subwoofer. Fully insert the
rigging pins (2) and rotate the arms until they are held in place by the clips.
This will further secure the rigging pins and also prevent them from rattling
from audio vibrations during operation.
Double check that all pins are correctly inserted,
before proceeding further.
 WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 2 TBV118L SUBWOOFERS FOR
1 TBV123-FB FLYBAR. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE
PERMANENT INJURY OR DEATH.
NOTE
Disassembly is the reverse of assembly.
Procedure 4.1 continued
2
1
2
1