Rigging Manual

26 TBV123 / TBV123-AN and TBV118L / TBV118L-AN Rigging Manual
1. Assemble the TBV123-FB ybar and a TBV118L subwoofer as shown in
procedure 4.1.
2. Attach the bow shackle or other lifting equipment securely to the ybar
mounting hole recommended by the EASE FOCUS II software, then attach
the hook and chain.
3. Carefully position the ybar/rst subwoofer assembly until it is on top of the
prepared TBV123 cabinet (with its mounting links (1) up). The front feet of
the subwoofer should t into the recesses on the top surface of the
TBV123 cabinet.
Take care not to trap your ngers between components.
Procedure 5.1 Assembling a Mixed Array on a TBV123-FB Flybar
4. Adjust the position of the mounting links (1) of the TBV123 cabinet to align
with the lower mounting holes of the subwoofer. Fully insert the rigging
pins (2) and rotate the arms until they are held in place by the clips. This will
further secure the rigging pins and also prevent them from rattling from
audio vibrations during operation.
Double check that all pins are correctly inserted,
before proceeding further.
2
1
2
1
2
5. If you are only adding one TBV123 cabinet, then this completes
the procedure.
6. Carefully hoist and position the ybar/subwoofer/cabinet assembly until it
is on top of the prepared lower TBV123 cabinet (mounting links (1) up). The
feet of the upper TBV123 cabinet should t into the recesses on top of the
lower cabinet.
Take care not to trap your ngers between components.