Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
Rigging Manual 27
7. Adjust the position of the mounting links (1) of the TBV123 cabinet to align
with the lower mounting holes of the upper TBV123 cabinet. Fully insert the
rigging pins (2) and rotate the arms until they are held in place by the clips.
This will further secure the rigging pins and also prevent them from rattling
from audio vibrations during operation.
Double check that all pins are correctly inserted,
before proceeding further.
8. This completes the mixed array assembly procedure.
WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 1 TBV118L SUBWOOFER AND 2 TBV123
CABINETS FOR 1 TBV123-FB FLYBAR. FAILURE TO FOLLOW INSTRUCTIONS MAY
CAUSE PERMANENT INJURY OR DEATH.
WARNING
THIS ARRAY SHALL ONLY BE MADE WITH THE TBV118L SUBWOOFER ON TOP, AND
THE TBV123 CABINETS BELOW. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE
PERMANENT INJURY OR DEATH.
NOTE
Disassembly is the reverse of assembly.
2
1