Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
Rigging Manual 33
4. A second TBV123 cabinet can be added to the ground stack. Lower it onto
the rst TBV123 cabinet and make sure its feet t into the recesses on the
top surface of the rst TBV123 cabinet. Attach it to the mounting links of the
rst TBV123 cabinet, and secure with the rigging pins in the same way as
shown in step 3.
Take care not to trap your ngers between components.
Double check that all pins are correctly inserted.
WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 2 TBV118L SUBWOOFER AND 3 TBV123
CABINETS FOR THIS GROUND STACK CONFIGURATION. FAILURE TO FOLLOW
INSTRUCTIONS MAY CAUSE PERMANENT INJURY OR DEATH.
NOTE
Disassembly is the reverse of assembly.