Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
Rigging Manual 35
Procedure 8.1 - Assembling a TBV123 Array Ground Stack
1. Prepare the TBV123-FB ybar by adding the extra mounting links
(supplied with the ybar) to the end of each arm. Lift the mounting links to
the upwards position.
Double check that all pins are correctly inserted,
before proceeding further.
2. Carefully position the TBV123 cabinet until it is on top of the prepared
TBV123-FB ybar. Remove the rigging pins from the top of the
TBV123 cabinet; these will be used to join the cabinet to the ybar.
Take care not to trap your ngers between components.
3. Adjust the position of the mounting links (1) of the TBV123-FB ybar to
align with the lower mounting holes of the TBV123 cabinet. Fully insert the
rigging pins (2) and rotate the arms until they are held in place by the clips.
This will further secure the rigging pins and also prevent them from rattling
from audio vibrations during operation.
Double check that all pins are correctly inserted,
before proceeding further.
2
1