Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
36 TBV123 / TBV123-AN and TBV118L / TBV118L-AN Rigging Manual
4. Lower the second TBV123 cabinet onto the rst TBV123 cabinet and make
sure its feet t into the recesses on the top surface of the rst TBV123
cabinet. Attach it to the mounting links of the rst TBV123 cabinet, and
secure with the rigging pins in the same way as shown in step 3.
Take care not to trap your ngers between components.
Double check that all pins are correctly inserted,
before proceeding further.
5. A third cabinet can be added in the same way.
Make sure that the nal assembly is securely tied down with
guy wires to prevent tipping. (The top cabinet’s unused
mounting links can be used to attach the guy wires.)
WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 3 TBV123 CABINETS FOR THIS GROUND
STACK CONFIGURATION. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE
PERMANENT INJURY OR DEATH.
WARNING
ALWAYS GROUND STACK THE TBV123 CABINETS WITH THE TBV123-FB FLYBAR TO
PREVENT TIPPING.
NOTE
Disassembly is the reverse of assembly.
NOTE
The TBV123 cabinet ground stack can also be assembled inverted on the ybar.
In this case, the lowest TBV123 cabinet uses its own mounting links and rigging
pins to attach to the ybar. This will create a mirror-image groundstack to
complement the ground stack described above.
Procedure 8.1 continued