Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
Rigging Manual 39
Inverted array
10.0.1 Required Components
Item Quantity
TBV123-FB Flybar 1 (maximum)
TBV123 Cabinet 4 (maximum)
10.0.2 Location
Move the rst TBV123 cabinet so it is sitting upright on a safe at surface,
directly below the suspension point.
10.0.3 Measured Weights
Please see Section 2.3 Weights on Page 9, and refer to EASE Focus Rigging
Parameters when designing your system.
TBV123-FB Flybar Working Load Limit (WLL)
Item Working Load Limit (WLL)
TBV123-FB 100 kg 220.5 lbs
Chapter 10: Assembling an Inverted TBV123 Array
The TBV123 cabinets may be mounted inverted on the TBV123-FB ybar to create
a mirror-image to complement TBV123 cabinets in their normal orientation. For
example, a normal array on the right would have its high-frequency drivers away
from the stage; an inverted array on the left would also have its high-frequency
drivers away from the stage
The following procedure shows how to build an array of inverted TBV123 cabinets
by adding them one at a time, up to a maximum of 4.
The system is own using a TBV123-FB ybar that attaches to your lifting system.
The top TBV123 cabinet connects to 2 mounting points on the ybar, using the
2 extra mounting links and rigging pins supplied with the ybar. Each TBV123
cabinet connects to the cabinet above using the integral mounting points and
rigging pins. No tools are required.
WARNING
DO NOT EXCEED A TOTAL QUANTITY OF 4 TBV123 CABINETS FOR 1 TBV123-FB
FLYBAR. FAILURE TO FOLLOW INSTRUCTIONS MAY CAUSE PERMANENT INJURY
OR DEATH.
10.0.4 Personnel
The following procedures shall be undertaken by experienced, certied,
qualied, and authorised personnel only. The procedures require the use of three
or more authorised persons.
Protective Headwear shall be worn
Protective Footwear shall be worn
Protective Gloves shall be worn
Protective Eyewear shall be worn
Practice Safe Lifting