Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
40 TBV123 / TBV123-AN and TBV118L / TBV118L-AN Rigging Manual
3. Adjust the position of the mounting links (1) of the TBV123-FB ybar to align
with the top mounting holes of the TBV123 cabinet. Fully insert the rigging
pins (2) and rotate the arms until they are held in place by the clips. This will
further secure the rigging pins and also prevent them from rattling from
audio vibrations during operation.
Double check that all pins are correctly inserted,
before proceeding further.
2. Invert the rst TBV123 cabinet and remove its rigging pins so the mounting
links drop down. Carefully position the TBV123-FB ybar until it is on top of
the inverted TBV123 cabinet.
Take care not to trap your ngers between components.
Procedure 10.1 - Assembling an Inverted TBV123 Array
1. Prepare the TBV123-FB ybar by adding the extra mounting links
(supplied with the ybar) to the end of each arm.
Double check that all pins are correctly inserted,
before proceeding further.
2
1