Rigging Manual
Table Of Contents
- Important Safety Instructions
- Legal Disclaimer
- Limited warranty
- Chapter 1: Safety Information
- Chapter 2: Introduction
- Chapter 3: Assembling a TBV123 Array on a TBV123-FB Flybar
- Chapter 4: Assembling a TBV118L Array on a TBV123-FB Flybar
- Chapter 5: Assembling a Mixed Array on a TBV123-FB Flybar
- Chapter 6: Assembling a TBV118L Ground Stack
- Chapter 7: Assembling a TBV118L Subwoofer and TBV123 Ground Stack
- Chapter 8: Assembling a TBV123 Array Ground Stack
- Chapter 9: Pole Mounting a TBV123 Cabinet on a TBV118L Subwoofer
- Chapter 10: Assembling an Inverted TBV123 Array
- Chapter 11: Using Eyebolts
- Chapter 12: Safety Inspection
- Chapter 13: TBV Enclosure Quantities and Combinations for TBV123-FB Flybar Suspension at 10:1, 7:1, 5:1 Design Factors
- Manufacturer’s Declaration
Rigging Manual 45
11.0.1 Required Components
Item Quantity
M10 x 40 mm 2 (minimum)
TBV123 As required
TBV118L As required
11.0.2 Measured Weights
Item Quantity Weight
TBV118L 1 37.0 kg 81.6 lbs
TBV123 1 22.0 kg 48.5 lbs
TBV118L-AN 1 38.5 kg 84.9 lbs
TBV123-AN 1 23.0 kg 50.7 lbs
11.0.3 Maximum Quantities
Maximum allowed quantities and system weights for 10:1, 7:1 and 5:1 design
factors. Ensure that eyebolts are specied with sucient WLL to support the
system weight at the desired design factor. It is recommended to check local
regulations regarding design factor requirements in order to comply with
regional codes.
10:1 Design Factor Eyebolt Suspension - Passive Or Powered
TBV118L-AN 3 2 1 0
TBV123-AN 0 2 3 4
System 115.5 kg 123.0 kg 107.5 kg 92.0 kg
Weight 254.6 lbs 271.2 lbs 237.0 lbs 202.8 lbs
7:1 Design Factor Eyebolt Suspension - Passive Or Powered
TBV118L-AN 5 4 3 2 1 0
TBV123-AN 0 2 3 5 6 6
System 192.5 kg 200.0 kg 184.5 kg 192.0 kg 176.5 kg 138.0 kg
Weight 424.4 lbs 440.9 lbs 406.7 lbs 423.3 lbs 389.1 lbs 304.2 lbs
5:1 Design Factor Eyebolt Suspension - Passive Or Powered
TBV118L-AN 6 5 4 3 2 1 0
TBV123-AN 0 1 3 4 5 6 7
System 231.0 kg 215.5 kg 223.0 kg 207.5 kg 192.0 kg 176.5 kg 161.0 kg
Weight 509.3 lbs 475.1 lbs 491.6 lbs 457.5 lbs 423.3 lbs 389.1 lbs 354.9 lbs
Chapter 11: Using Eyebolts
The various arrays shown in this manual may be own using 2 eyebolts instead of
the TBV123-FB ybar.
The recommended eyebolt is M10, with a thread greater than 18 mm, and a
working load limit adequate for the size of the specic array to be suspended.
Third party eyebolts must be specied and supplied by authorised,
qualied personnel.
The system is own with 2 two eyebolts securely attached to the threaded holes
in the top surface of the uppermost TBV123 cabinet or TBV118L subwoofer.
Two threaded holes are also provided on the bottom surface. These can be used
with eyebolts for tether points, or for ying the systems inverted.
WARNING
DO NOT EXCEED THE QUANTITY OF TBV118L SUBWOOFERS OR TBV123 CABINETS
SHOWN IN 11.0.3 THE TABLE OF MAXIMUM QUANTITIES. FAILURE TO FOLLOW
INSTRUCTIONS MAY CAUSE PERMANENT INJURY OR DEATH.
DO NOT EXCEED A MAXIMUM 2LEG BRIDLE HITCH ANGLE OF 60 DEGREES FOR
SINGLE POINT SUSPENSION CONFIGURATIONS. FAILURE TO FOLLOW INSTRUCTIONS
MAY CAUSE PERMANENT INJURY OR DEATH.
11.0.4 Personnel
The following procedures shall be undertaken by experienced, certied,
qualied, and authorised personnel only. The procedures require the use of three
or more authorised persons.
Protective Headwear shall be worn
Protective Footwear shall be worn
Protective Gloves shall be worn
Protective Eyewear shall be worn
Practice Safe Lifting