Quick Start Guide

12
TCS Passive R series Quick Start Guide
13
Mounting and Fixing
The table below summarises the rigging parts or kits required for various applications, and some examples
of the possible rigging options are illustrated.
TCS series cabinets are designed with multiple internal rigging points to suit many possible mounting
methods in permanent installations. All cabinets can be simply suspended using optional M8 or M10
shoulder eyebolts coupled to the internal rigging points provided. Remove the appropriate countersunk
screws and replace them with eyebolts, which must have a thread length of at least 18mm. Use the rear
rigging point to angle the cabinet for optimum room coverage. Cabinets may be hung upside down if
required. Turbosound WB-20, WB-55 and CB-55 wall and ceiling brackets are optionally available for TCS
series cabinets, and these are also compatible with OmniMount* wall and ceiling brackets which use
60 mm x 60 mm hole spacing.
Some typical examples of the possible rigging options are shown here:
Model Wall Ceiling Downfi ll Array Kit Eyebolts
TCS62-R
WB-20
TCS62-SB
CB-55
TCS62-SB
TCS62-SB M8 Thread
TCS122-R WB-55 CB-55
TCS122-FP
TCS-FK1
TCS-FK2
EB-10-40
TCS152-R WB-55 CB-55
TCS152-FP
TCS-FK1
TCS-FK2
EB-10-40
TCS115B-R
TCS115-FP
TCS-FK3
EB-10-40
TCS-R Subwoofers EB-10-40
Passive
>
>
LF
RED +
BLUE -
2-core
cable
tail
Mode Back Panel Internal Schematic
Parallel or
Discrete are
configured
with external
connection
LF 1
>
>
LF 2
4-core
cable
tail
RED SUB 1 +
BLUE SUB 1 -
YELLOW SUB 2 +
GREEN SUB 2 -
>
>
Mode Back Panel Internal Schematic
TCS115B-R
TCS218B-R