Quick Start Guide

8
TPA/TPZ series Quick Start Guide
9
Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further
information about this or any other product, please visit our website at turbosound.com.
Unpacking the Loudspeaker
After unpacking the unit, please check carefully for damage. If damage is found, please notify your
supplier at once. You, the consignee, must instigate any claim. Please retain all packaging in case of future
return shipment.
System Requirements
TPA122, TPA152, TPZ122 and TPZ152 are switchable passive / bi-amp 2-way loudspeakers.
Passive operation (full range or with a subwoofer) requires 1 amplifi er channel and 1 controller channel.
The input signal is divided between the low-frequency and high-frequency drivers internally with a
passive crossover.
Bi-amp operation (full range or with a subwoofer) requires 2 amplifi er channels and 2 controller channels,
one for low frequencies and one for high frequencies. The input signal is divided between the low
frequency and high frequency driver in the controller and the individual amplifi ed signals are fed to the
speaker input.
TPZ153 is a switchable bi-amp / tri-amp 3 way loudspeaker.
Bi-amp operation (full range or with a subwoofer) requires 2 amplifi er channels and 2 controller channels,
one for low frequencies and one for mid-high frequencies. The input signal is divided between the low
frequency and mid-high frequency drivers in the controller and the individual amplifi ed signals are fed
to the speaker input. The signals are then divided again between the mid and high frequency drivers
internally with a passive crossover.
Tri-amp operation (full range or with a subwoofer) requires 3 amplifi er channels and 3 controller channels,
one for low frequencies, one for mid frequencies, and a third for high frequencies. The input signal is
divided between the low frequency, mid frequency, and high frequency drivers in the controller and the
individual amplifi ed signals are fed to the speaker input.
Correct controller settings for all horn variants and operation with subwoofers can be downloaded from
the website, and are also available as presents for the LMS series controllers.
To avoid wasting amplifi er power, you should use heavy-duty speaker cable with a minimum wire size of
1.5 mm
2
(16 AWG), and preferably 2.5 mm
2
(14 AWG) for longer runs. For extreme cable lengths, be aware
of cable impedance and resistive losses. Always observe the correct polarity.
᧙᜷ᄋ߸Мᮍᅽ
ࣝధ൦ಗ঄ᄋጽቬ᝻ܭЧధ
ܹᄋႄุߜڛᝐႄԁᬘǎᬎ
Ώၺࣝధ ¼" TSᩛତ݁
ᄋᰵַ᠐˅ˋܧ٩ጴǎధᄋ߸ᜊួ
஠ڪᮍႁՍಬᄋ˅ˋցᤊᛢǎ
൦ಗ঄ଣᧉ১ַаߜڛఴ
ፑᎇᄋԁᬘႄԎధᝐႄԁᬘǎ
൦ಗ঄ଣᧉ১ಋ󰪀ᬅᄋ᧙᜷
ᄋΏၺԤ፦οឮ௛ǎឱ󰪀឵ధ
Угǎ
࠶
˟ᥙГᝐႄԁᬘឱӉ఼
ᮈᄧᑁ᭨૖ౝǎ᝻ܭа෦
ధԼΚၺ፦οΏၺᄋᦋǎឱ࠳፦ο
ᮋႁՍಬᄋ˅ˋցᤊᛢǎ
࠶
˟ᥙГᅍ༣ᝐႄԁᬘឱӉ
࠳൦᝻ܭᎷᭂ๹໾ິ˘ǎ
൦᝻ܭ˸ˁԼԫ๰͵໠ຶᄪధ๰͵ᄋࠕ
٩˸ˁԼᎷЦʾݡᔊၬ኏ǎ
࠶
፦οឮ௛௨ፍՍಬᄋ˅ˋ፦
οցΏၺᄋǎ˟ᥙГᝐႄԁ
ᬘᬕΏၺឮ௛˻ଣ҃ᄋܲឱӉᤊᛢ
ͶЦ߳፦οǎధ፦οڪᮍႁՍಬᄋ˅
ˋցᤊᛢǎ
1. ឱ󰪀឵ᤉឮ௛ǎ
2. ឱݱؔεߜᤉឮ௛ǎ
3. ឱญధᄋ᝞ᇩǎ
4. ឱᥗ߷ధᄋឮ௛ǎ
5. ឱӉڛ᭦ᤄබᄋڢஶΏၺశַǎ
6. ឱၺࣱ࣌ຎพశַǎ
7. ឱӉ܅܌ᤱ᮴Աǎ߸ᜊశַ௒ឱᥗ
ཱིԉࠓᄋឮ௛ǎ
8. ឱӉ࠳శַ߸ᜊڛམ຺ᬅᤄ
ݡ఍ජྠ༰ߖЦ߳ၸམ᧛ᄋ᝻ܭ
Ӌ઻ҫ஋٩ǎ
9. ឱӉሩᬕ౞মତ݁଍ڢତ݁ᄋ߸М
ᜊᎷǎ଍ڢତ݁௨ႁˑ˕ତ܌଍གྷԤʸ˕
଍ڢ݁౟ǎᔫᬥ᠏ଣΚᄋତ݁ˁᤡՍ১
ᄋତឱႄࢻట૲ʸ˕Սᤡᄋତǎ
10. ݱؔεઑႄ຺ጴΏЦˁᜃ᡼ᢇ҉
ᆢࡀЦญႄ຺ତ݁Ǎܴၺ᤮ତԤ᝻ܭ
ᤍ଍ܬǎ
11. ឱԷΏၺԉࠓ૊ࠁᄋᬅ࡜᝻ܭ֘ᦢǎ
12. ឱԷΏၺԉࠓ
૊ࠁᄋᬥ᠏ᩚ
׭ᄋଏᢽ౷ߖ
ʽᝉ౷஄౷֘ಹ
ߖǎᔫΏၺଏᢽ
౐ୄᤃ᝻ܭឱญ
߸М஋Ꮇ᝻ܭ
ᥙГଏᢽ֘᝻
ܭϛωᏬԫǎ
13. ᥆󰩧ႄᭈᲟ󰩤ఱˁΏၺశ᝻ܭ௒
ឱફѤႄ຺ତ݁ǎ
14. ధ፦οڪᮍႁՍಬᄋ፦οցᤊ
ᛢǎ᝻ܭԫ૰௒ᭋᤊᛢ፦οΔݡႄ຺ጴ
ႄ຺ତ݁ԫ૰๰͵ุЛྮᗁЛ᝻ܭ
а᝻ܭᥔᭂ๹ԫ໾᝻ܭˁᑠ൥ࣣᤃͼ
ᜃ୒گǎ
15. శ᝻ܭᤍ଍ႄ຺௒ʸࠁ᜷ధ଍ڢ
εઑǎ
16. ᔫႄ຺ତ݁٩Ч
ᏺՍ٩ၺͼளႄᜊᎷ
ε᝾߳ܬᬥ௒Լ
ஶΨ୳ͼ࿅ঘǎ
17. శַᤡၺ๓ફ
2000ዜʿڢӞశַ
ᤡၺ᭥མࣝජό౏
ʿǎ
ฃܧ௛
ࠬͶڃڛ൦ឮ௛˻ଣ҃ᄋМᦋ
ᦋଢᤙǍڐྠܧ௛Ꮼᤶᄋ૰
݀MUSIC Groupˁ᠈Ͷ᠋ǎ
઀సԡஞ֘ܲ᜻ᔫధటஉিˁԴᛢ
ᤱᅽǎధᄋ׹ಗڪ˟ЦՋᒮధᏩ
ᄋ᠊ǎMIDASKLARK TEKNIK
TURBOSOUNDBEHRINGERBUGERA
֘DDA௨MUSIC Group IP Ltd.ОՄᄋ
׹ಗญг׹ಗǎ© MUSIC Group IP
Ltd. 2014ྡీధǎ
εο౏൝
ధУᮄˮᬸڅεοᄋᤡၺ౏
൝ԤЦ߳ᄲУθ্ឱᄇᬇ
music-group.com/warranty
Ꭻቤಋᄻߺ஠ᄋឡጻθ্ǎ