Data Sheet

THUNDERCOMM TurboX C403-C Datasheet

This device is intended only for OEM integrators under the following conditions: 1. The antenna

must be installed such that 20 cm is maintained between the antenna and users. 2. The transmitter

module may not be co-located with any other transmitter or antenna. As long as the two conditions

above are met, additional transmitter testing will not be required. However, the OEM integrator is

still responsible for testing their end-product for any additional compliance requirements required

for the installed module.

Important Note: In the event that these conditions cannot be met (for example certain laptop

configurations or co-location with another transmitter), then the Federal Communications

Commission of the U.S. Government (FCC) and the Canadian Government authorizations are no

longer considered valid and the FCC ID cannot be used on the final product. In these circumstances,

the OEM integrator shall be responsible for re-evaluating the end-product (including the transmitter)

and obtaining a separate FCC authorization in the U.S. and Canada.

OEM Integrators - End Product Labeling Considerations: This transmitter module is authorized

only for use in device where the antenna may be installed such that 20 cm may be maintained

between the antenna and users. The final end product must be labeled in a visible area with the

following: “Contains, FCC ID: 2AOHHTURBOXC403C”. The grantee's FCC ID can be used only when all

FCC compliance requirements are met.

OEM Integrators - End Product Manual Provided to the End User: The OEM integrator shall not

provide information to the end user regarding how to install or remove this RF module in end

product user manual. The end user manual must include all required regulatory information and

warnings as outlined in this document.