TURBO WN LFS ELECTRIC LOG SET [a [Sens] EFF-LG IMPORTANT SAFEGUARDS READ ALL INSTRUCTIONS BEFORE USE.
Contact us: supportfiurbro.com WWW. birdie. oom Contents sews sas saran sacrosanctness OF Safety Information iii 02 Pr-installation cin scans. D4 Installation oes ss asses 000ee0e (JF Operation. « cc recent conversant FCC Information ous sos 10 Troubleshooting «cco ccc levee 11 Warranty. «+ +c «vv civ i iin tics ii iss c ise e no 12 Any attempt to disassemble or modify the product may VA WARN Le cause damage.
Contact us: supportfiurbro.com WWW. purebred. oom Safety Information Please read all instructions before implicating fo assemble, operate or Install the product. © Do not use this fireplace with missing, damaged, or broken lags. © Do not use outdoors. + This fireplaces Is not Intended for use In bathrooms, laundry areas, and similar Indoor locations. Do not place this appliance where it may fall inch a bathtub or other wale containers. © This appliance is hot when in use.
Contact us: supportfdiurbro.com WWW. purebred. oom Safety Information NE ELECTRICAL CONNECTION ull A 15-Amp, 120-Volt, 60 Hz circuit with a properly grounded outlet Is required. Preferably, the Item 2 will be on a dedicated circuit. Having other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the fireplace Is In operation. The unit comes standard with a 611. (1.8 m) long three wire cord, which can be found on the right side of the appliance.
Contact us: supportfiurbro.com WWW.IUDI0. 00m EE ey The fireplace should be located In an area: = Dut of direct sunlight * Not susceptible to moisture ® Away from insulated outside wall ® The fireplace is heavy and constants glass, you need move It carefully ic prevent injury. = Do not install the unit on shelves, raised platforms, beds, blankets, pillows ste. Keep combustible materials such as furniture, bedding, papers, clothes and curtains at least 3 ft. {1m} from the fireplace.
Contact us: supportfdiurbro.com WWW. purebred. oom Using the Control Panel 0 €) LCD Screen €) indicators € Timer 3 Heater ON/OFF © Flame control {3 Main power © rec HEE @ Press the Main Power Button oO once to tum on the fireplace. The flame effect will be on automatically. To enter the heating mods, please press the Heater ON / OFF Button oO € Understanding the function Indicator There are three LED indicators below the LCD screen red, gran, and blue.
Contact us: supportfdiurbro.com WWW. purebred. oom § Change the Temperature Scale Temperature (°F) 95°F 94°F 93°F I. 72°F 71°F 70°F Temperature (°C) | 35°C 34°C 33°C 23°C 22°C 21°C 1. With the heater on and the temperature is displaying with Fahrenheit scale, the indicator is red. 2. Gently press and held the Main Power Button for § seconds to stern the temperature scale converting mode. 3. The LED indicator flashes 5 times in red, then changes to green.
Contact us: supportiiurbro.com WWW.IUDI0. 00m @ Using the timer function The Timer Button © controls both the flames and the heater function. 5 @ if the heater is operating when the timer is set, then the heater is under the control of the timer. 3 @ If the flame function Is operating wham the timer is set, then the timer will control the flame. @ if both the heater and flames are operating with the timer set, then the timer controls both the flames and the heater.
Contact us: supportiiurbro.com WWW.IUDI0. 00m @ Using the Remote Control The remote control Is working within 13ft (metatarsi) away from the heater SE {without obstacles between the remote control and the fireplace) C Main Power o Heater Control < Flames Control {ie Temperature Up Timer Function: © & & Temperature Down v REC: Remotes Control Receiver @ INSERTING BATTERIES IN THE REMOTE Press and glide the bestiary cover on tha rear of the remote, remove the cover. Insert bye new ROS "AAA" 1.
Contact us: supportfdiurbro.com WWW. purebred. oom FCC/C Information Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance coil void user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of tha FCC Rules. These limits are designed to provide reasonable protection against harmful Interference In a residential installation.
Contact us: supportfdiurbro.com WWW. Eureka. cont Troubleshooting Problem The fireplace does not operate. Disconnect power before servicing. Possible Cause ® The fireplace is not plugged in. » & giro breaker is tripped or a fuse blown. * The ON/OFF switch ie defective. = There is loose wiring. Lodge = Marks sure the fireplace is plugged into a standard 120V outlet. = Hack additional appliances on the circuit; ideally the fireplaces should be on a dedicated 15-amp circuit. = Contact customer service.
Contact us: supportiiurbro.com WWW.IUDI0. 00m 1-YEAR WARRANTY TURBO provides 1-year limited warranty for TURBO ETERNAL FLAME Log set, from the date of purchase, subject to the following conditions and imitations. What is covered? # Any rationalist misuse of the product will nullify this warranty. = This warranty is non-transferable, which is effective for the original buyer from the authorized seller only.
