ELECTRIC FIREPLACE INSERT INF23 INF26 INF33
Contact us: support@turbro.com Contents www.turbro.
Contact us: support@turbro.com www.turbro.
Contact us: support@turbro.com www.turbro.com This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
Contact us: support@turbro.com www.turbro.com You may run the power cord out of the framed wall opening to an existing outlet or install an outlet on a nearby wall stud within the wall. In order to use the power safely, please make sure: NEVER use the relocatable power tap/outlet/power strip. NEVER exceed the maximum amperage for the circuit (Should be 120V 15amp). NEVER plug other appliances into the same circuit. SHOULD make sure the plug is in good condition and not loose.
Contact us: support@turbro.com www.turbro.
Contact us: support@turbro.com www.turbro.com SPECIFICATIONS Power Supply 110-120V / 60Hz Rated Current 13.6A Rated Power 1500W / 5280BTU Adjustable Thermostat 62OF- 82OF Heating Area 400 - 1000sq.
Contact us: support@turbro.com www.turbro.com RECESS INTO A WALL Prepare the opening and outlet. Place the unit into the framed opening gently and no fixing brackets are needed. Width Height Depth Opening sizes ranges (mm) Model Width Height Depth(min) Depth(suggest) IFN22 580-610 450-460 195 205 IFN26 655-685 450-460 235 245 INF33 830-860 680-690 235 245 INSERT INTO A CABINET OR WOOD MANTEL Make sure the depth is enough for placement: 7.
Contact us: support@turbro.com www.turbro.com USING THE CONTROL PANEL 5 3 4 2 1 2 3 4 5 1 Digital Display 4 Flame Control 2 Timer Setting 5 Power Button 3 Thermostat Control The buttons on the control panel and the remote control function in the same way. POWER BUTTON Press the power button once to power on. Press the power button once to power off. NOTE: After the heater turning off, it will continue to produce wind for 30 seconds to cool off the heater.
Contact us: support@turbro.com www.turbro.com THERMOSTAT CONTROL Press the thermostat control button once to turn on or off the heater. Press the thermostat control button once, then press again and hold this button for 5 seconds to enter the temperature setting mode. See the tables below for detailed temperature settings instruction. Press and hold the power button for 5 seconds to switch between Fahrenheit(OF) and Celsius(OC) display.
Contact us: support@turbro.com www.turbro.
Contact us: support@turbro.com www.turbro.
Contact us: support@turbro.com www.turbro.