Installation Guide

06
This product is equipped with a 3-pin polarized plug.
Connect to properly grounded outlets only. This unit is for use on 120 volts outlets only. For your safety, please always
plug the unit into a wall outlet/receptacle. An extension cord or power tap (outlet/power strip) should never be used with
this device.
WARNING: If it is necessary to hard wire this appliance, a qualified electrician will be required to remove the cord
connection and wire the appliance directly to the household wiring. The wire and power supply breaker must be rated for
120V minimum 15 amps.
This appliance must be electrically connected and grounded in accordance with local codes, if hard wired. In the absence
of local codes, use the current CSA C22.1 CANADIAN ELECTRICAL CODE in Canada or the current ANSI/NFPA 70
NATIONAL ELECTRICAL CODE in the United States.
1. Remove the 2 pcs screws to release the cover of the junction box, which is located on the top left side of the appliance.
2. Pull the junction box out. loosen the screws in the terminal block to release the wires of the power cord.
Hard Wire Connection
This fireplace can either be plugged into a grounded 3-prong outlet or a hard wire connection.
Wiring