Installation Guide

______________________________________________________________________________________
Turf
Evolutions, LLC 100 Executive Way phone 866-966-TURF
Suite 108 fax [phone]
[e-mail] Ponte Vedra Beach, FL 32082 www.turfevolutions.com
Installing Cups
1. Layout cups with customer and begin digging holes, with post-hole digger, for
cup sleeve and cup. Try to set cups in areas where base is relatively flat and level.
2. Dig hole with width of digger and approximately 12” deep. Save stone from base
if possible.
3. Will need 4” perforate drain tile to use as a
sleeve for cups. Cut tile to 18” in length.
Make an 8-10” vertical cut down the drain
tile, place cup inside and duct tape the gap,
making cup snug inside tile. The top of the
cup and drain tile should be the same.
4. After hole is dug and sleeve is made, place
sleeve in hole and place stone around sleeve to level and make stable. Each layer
of material must be tamped tight around sleeve. Once sleeve is stable and level to
top of base, place a couple inches of fast setting, Quick Crete around sleeve, add
water and tamp until stable. Once Quick Crete is in and sleeve is stable and level,
layer stone and Quick Crete around sleeve until blend is 1.5”-2” from the top. At
this point place stone dust around sleeve, tamp and smooth with trowel making
sure it ties in seamlessly with surrounding base.
Turf Layout/Seaming and Gluing
1. On the smooth stone base, use marking paint to outline the outside shape of the
Bentgrass Putting Green.
2. Roll out the turf and cut the shape to match
the outline, using standard carpet cutting
knife.
3. When two or more pieces are need for the
size and shape of the green, the pieces will
have to be seamed together.
4. Using a carpet knife, trim the selvage edge off one piece of the turf and lay it over
the second piece of turf.