Installation Guide

______________________________________________________________________________________
Turf
Evolutions, LLC 100 Executive Way phone 866-966-TURF
Suite 108 fax [phone]
[e-mail] Ponte Vedra Beach, FL 32082 www.turfevolutions.com
5. Using a carpet seaming knife, closely follow the trim the selvaged edge while
cutting the piece of turf underneath.
6. Pull out the trimmed piece and lay the seam together and check for any gaps or
overlapped pieces.
7. Once the seam looks good, pull back both pieces of the seam turf to about 18” and
place a 12” piece of geotextile down the seam line.
8. Using glue and spatula spread adhesive to about 8” width down the middle of the
geotextile where the seams will go together.
9. Carefully lay down the pieces of Bentgrass and press the seam into the adhesive.
10. Once the seam is complete, find the cup locations and cut the turf around the cup
exposing the cup.
11. Bring the cup level to about 1/8” below the turf level.
12. Place the hole marker flags in the cups and enjoy.
**If placing TruGrass around the Bentgrass putting surface, follow the steps below.
13. At this point green will be in place, seamed and cut. TruGrass for apron must be
measured and cut to length and at least 5’ wide depending shape of green and
amount of TruGrass on site.
14. Roll back all four sides of the Bentgrass and place pieces of TruGrass under
making sure to overlap painted line, which marks the edge of the Bentgrass.
15. Place Bentgrass on top of TruGrass making sure there are no major wrinkles or
bubbles.
16. Using the same carpet knife with the foot, use
Bentgrass as guideline and cut the shape of the
inside apron which will be glued to the putting
surface.
17. Once all cuts are made and pieces are fit in,
secure apron with sand bags so they do not lose
their place. Roll back Benrgrass again and
remove wasted TruGrass.