Installation Guide

ManualsBrandsTurf Evolutions ManualsOther5 ft. x 10 ft. TruLine Platinum Putt Indoor/Outdoor Turf

______________________________________________________________________________________

Turf

Evolutions, LLC 100 Executive Way phone 866-966-TURF

Suite 108 fax 904-827-9426

info@turfevolutions.com Ponte Vedra Beach, FL 32082 www.turfevolutions.com

Turf Evolutions Putting Greens Installation Process

Below you will find an abbreviated installation process for our TruLine Bentgrass putting

greens. Our greens have a true roll, and will hold a shot giving the player a very natural

response.

Base Construction

1. Remove the organic topsoil with skid steer or sod cutter and take off site.

2. At the depth of compactable soil, make sure

the base is sloped to drain any water that may

protrude into base cavity. Soils should be

either crowned or sloped in one direction, then

compacted with roller.

3. Depending on surroundings, a drain tile may

be needed on low side of green to take water

away from cavity. In this case, dig trench

large enough to lay in clean drain stone, 4”

perforated drain tile, and cover with another layer of clean stone.

4. Add and shape layer of ¾’- crushed stone within 2” of the height of surrounding

grass, then compact with roller to 95%.

5. Add and shape 2” of stone dust to make final

grade. The final grade should be a smooth

and compacted as possible with undulations,

crown or slope that was shaped in step 2.

6. When compacting base you may have to keep

material dampened to maximize compaction.

**Base requirements may be less depending

on region of the country. If solid sub grade in arid climate, may only need 2” on

compacted fines/screenings.

Summary of content (4 pages)

PAGE 1
Turf Evolutions Putting Greens Installation Process Below you will find an abbreviated installation process for our TruLine Bentgrass putting greens. Our greens have a true roll, and will hold a shot giving the player a very natural response. Base Construction 1. Remove the organic topsoil with skid steer or sod cutter and take off site. 2. At the depth of compactable soil, make sure the base is sloped to drain any water that may protrude into base cavity.
PAGE 2
Installing Cups 1. Layout cups with customer and begin digging holes, with post-hole digger, for cup sleeve and cup. Try to set cups in areas where base is relatively flat and level. 2. Dig hole with width of digger and approximately 12” deep. Save stone from base if possible. 3. Will need 4” perforate drain tile to use as a sleeve for cups. Cut tile to 18” in length. Make an 8-10” vertical cut down the drain tile, place cup inside and duct tape the gap, making cup snug inside tile.
PAGE 3
5. Using a carpet seaming knife, closely follow the trim the selvaged edge while cutting the piece of turf underneath. 6. Pull out the trimmed piece and lay the seam together and check for any gaps or overlapped pieces. 7. Once the seam looks good, pull back both pieces of the seam turf to about 18” and place a 12” piece of geotextile down the seam line. 8. Using glue and spatula spread adhesive to about 8” width down the middle of the geotextile where the seams will go together. 9.
PAGE 4
18. Roll back inside edge of TruGrass and place pieces of geotextile over painted guideline on stone base and trace painted line with making pen or crayon. 19. Repeat step 5 and secure with bags of sand. 20. Once seams have had a chance to dry, cut outside of apron with carpet knife. 21. To stand the fibers upright and add weight for ballast, top dress the TruGrass with two pounds of medium grade sand, per square foot.