Product Manual

Professional Model Infill Depth Gauge
Instructions
Professional Model Infill Depth Gauge - IDG1-M
Measures from 0 to 2 inches or 0 to 50 mm
Aluminum and Stainless Steel construction
Weight - 8.5 oz
Instructions
1. Place bottom aluminum foot plate firmly on infill surface
2. Slide black center shaft down until three stainless steel spikes make firm contact
with carpet backing
3. Lift out and read gauge in inches or millimeters
4. Note, you should check 2 or 3 areas at each location to get the average infill for
that test area.
5. Test wear areas more frequently as these areas are usually where the infill is
dispersed more frequently.
Also keep in mind that infill does not break down, it often is just re-distributed to other
areas of the playing surface. Proper grooming may even out the infill better than the
addition of more infill.
IDG1-M - Professional Model Infill Depth Gauge