Installation Instructions

ManualsBrandsTurn of the Century ManualsCeiling Fan Lights3-Light White Ceiling Fan Light Kit with Frosted Swirl Shades

121018

Turn of the Century

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT

BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.

NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless

additional support is provided for the fan.

355-4812 / 355-4825

1. Unscrew the three screws from the switch box, remove

the switch box cover and disconnect the wire nuts.

(See Fig. 1)

2. Push the center plug from inside the switch box cover

to remove the center plug. (See Fig. 1)

Note: Save the center plug should you choose to

remove the light fixture in the future.

3. Feed the two wires from the fan light kit through the

center hole in the switch box cover, and thread the

wires through the washer and hex nut, then secure

switch box cover onto the fan light kit with a hex nut

and washer. (See Fig. 2)

4. Connect wires by using the wire nuts: (See Fig. 2)

---The black (hot) wire from fan light kit to the black (hot)

wire from the fan.

---The white (neutral) wire from fan light kit to the white

(neutral) wire from the fan.

---Carefully put wires back into the switch box.

5. Restore the switch box cover back to the switch box by using the three screws. (See Fig. 2)

6. Use fingers to screw glass shades into glass holder. (See Fig. 2)

CAUTION: Over tightening the set screws could result in breakage of the glass shade.

7. Install bulbs (included). See relamping label at socket area or packaging for maximum

allowed wattage. (See Fig. 2)

8. Turn on the electric circuit.

Motor

Switch Box

Hex Nut

Screw

Switch Box Cover

Nipple

Wire Nut

Washer

Center Plug

Light Kit

Glass Shade

Glass Holder

Bulb Type A Max.60W

(included)

----This FAN LIGHT can be installed in one of two ways.

----This fan light is not compatiable with ceiling fans

containing an integrated light kit.

Fig.1.

Switch Box Cover

Screw

Switch Box

Fig.2.

Set Screw

Wire Nut

WARNING:

As per EPACT 2005 requirements, this fan light has a built-in current

limiting device to conserve energy. The fan light will not operate if the

combined wattage of the installed bulbs exceeds 190 Watts. If the fan

light shuts off shortly after being switched on, it may be due to

excessive current demand. You should replace the light bulbs with

lower wattage bulbs.

Installing the fan light on fans with Non-Removable

switch box:

Summary of content (2 pages)

PAGE 1
ASSEMBLY AND INSTALLATION INSTRUCTIONS 355-4812 / 355-4825 WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE. NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. The combined weight of your ceiling fan and light kit cannot exceed 35 pounds unless additional support is provided for the fan.
PAGE 2
Installing the fan light kit on a removable switch box: 1. Unscrew the three screws from the fan, remove the switch box and disconnect the terminals. (See Fig. 3) 2. Push the center plug from inside the switch box to remove the center plug. (See Fig. 3) Save the center plug should you choose to remove the light fixture in the future. 3.