Installation Instructions

Fig. 4
Terminals
121017
Turn of the Century
TM
1. Unscrew the three screws from the fan, remove the
switch box and disconnect the terminals. (See Fig. 3)
2. Push the center plug from inside the switch box to
remove the center plug. (See Fig. 3)
Save the center plug should you choose to remove
the light fixture in the future.
3. Thread the two wires from the ceiling fan through the
center hole in the switch box, then thread the wires
through the washer and hex nut, then secure switch
box onto the ceiling fan with a hex nut and washer.
(See Fig. 4)
4. Remove the wire nuts from the two wires in the
switch box labeled “FOR LIGHT KIT CONNECTION”.
(See Fig. 5)
5. Connect wires by using the wire nuts: (See Fig. 5)
---The black (hot) wire from fan light kit to the blue
(hot) wire from the switch box.
---The white (neutral) wire from fan light kit to the
white (neutral) wire from the switch box.
---Carefully put wires back into the switch box.
6. Connect the two terminals respectively from the fan
and switch box. (See Fig. 6)
7. Restore the switch box back to the fan by using the
three screws. (See Fig. 6)
8. Install bulbs (included). See relamping label at socket
area or packaging for maximum allowed wattage.
(See Fig. 6)
9. Slip the short nipple up through the pull chain, and
secure it into the coupling with hex nut. (See Fig. 6)
10. Slip the glass shade up through the pull chain and
the short nipple, secure them with a rubber pad,
metal pad and hex nut. (See Fig. 6)
11. Slip the cover up through the pull chain and the short
nipple, secure it with finial. (See Fig. 6)
12. Turn on the electric circuit.
Switch Box
Hex Nut
Fan
Nipple
Wire Nut
Washer
Center Plug
Ceiling Fan
Fig.3.
Screw
Switch Box
Fig. 5
Switch Box
Terminals
Terminals
Black Wire from
Fan Light
Blue Wire from
the Switch Box
White Wire from
Fan Light
White Wire from
the switch Box
355-3151 --- Page 2
Ceiling Fan
Coupling
Pull Chain
Glass Shade
Hex Nut
Rubber Pad
Metal Pad
Cover
Finial
Bulb Type A15
Max.60W (included)
Hex Nut
Short Nipple
Installing the fan light kit on a removable switch box:
Screw
Terminals
Switch Box
Fan
Fig. 6