User Manual

(keep the switch in
‘OFF’ position),
Correctly connect
the ESC with
brushless motor,
receiver and
battery pack. Move
the throttle to the
highest position,
turn on the
transmitter; power
on the receiver,
switch ‘ON’ the
switch. There are
three beeps
emitted from motor,
which indicates the
electronics are
correctly power on
for the setting.
There are 4
long beeps
emitted from
the motor
Move the
throttle down to
lowest position,
at this point,
you have
calibrated the
throttle range of
your transmitter
7 beeps
indicate you
already have
entered the
programmable
setting
The 1
st
beep:
Low
Cutoff
Voltage
The 2
nd
beep:
Current
Limiting
The 3
rd
beep:
Brake
Type
The 4
th
beep:
Timing
Advance
The 5
th
beep:
Cutoff
Type
The 6
th
beep:
Start
Type
The 8
th
beep:
PWM
Switching
Rate
reserve
The 10
th
beep:
EXIT
The 7
th
beep:
Governor
Mode
Move the throttle to the lowest position
One beep
indicates you
have entered
the Low
Cutoff
Voltage
Setting.
1
st
beep:Auto lipo
2
nd
beep:4S
(default)
3
rd
beep:5S
4
th
beep:6S
5
th
beep:7S
6
th
beep:8S
7
th
beep:9S
8
th
beep:10S
9
th
beep:11S
10
th
beep:12S
Three beeps
indicates you
have entered
the Brake
Type Setting.
1
st
beep:Brake
Disable
(default)
2
nd
beep:Soft
Brake
3
rd
beep:Hard
Brake
Four beeps
indicates you
have entered
the Timing
Advance
Setting.
1
st
beep:Low
Advance
2
nd
beep:Middle
Advance
3
rd
beep:High
Advance
4
th
beep:Auto
Timing
(default)
Five beeps
indicates you
have entered
the Cutoff
Type Setting.
1
st
beep:Hard
Cutoff (default)
2
nd
beep:Soft
Cutoff
Six beeps
indicates you
have entered
the Soft Start
Setting.
1
st
beep:Very
Soft Start
2
nd
beep:Soft
Start (default)
3
rd
beep:Fast
Start
Seven beeps
indicates you
have entered
the Governor
Mode
Setting.
1
st
beep:Auto
Calibrating
Throttle
(default)
2
nd
beep:
Governor Low
3
rd
beep:
Governor High
Eight beeps
indicates you
have entered
the PWM
Switching
Rate Setting.
1
st
beep:Low
(default)
2
nd
beep:1Middle
3
rd
beep:High
Move the throttle to the highest position
Three beeps emitted from motor indicated your setting is successful
Two beeps
indicates you
have entered
the Current
Limiting
setting.
1
st
beep:Very
sensitivity
2
nd
beep:Standard
(default)
3
rd
beep:
Insensitivity
4
th
beep:Disable
Waiting one
second, there
will be two
beeps emitted
from the
motor
GO FLY
GO FLY
Figure. 1 : Operational Flowchart for Programming the ESC with Throttle
Main Loop
* We recommend to calibrate
your throttle when you first use
the controller.