User Manual

So, why do we need to do these changes, couldn't just the manufacturer deliver correct software in the first
place?
Well, I guess that the configuresation is correct for the HiFei King Kong esc's, but not for Turnigy Super
Brain esc's and HobbyKing is cheap.
If not, then I don't know why, only thing I know is that by doing these changes the graph will be alot more
accurate and that is all I need to know.
After reading alot on forums about Super Brain esc there is some people complaining about burned motors
when using this esc, I may be wrong, but I dont think it is the esc's fault, I think they have looked at the
recorded current from the esc, and since it is showing way to low they have overpropped their motors
resulting in way to much load on the motor.
There has also been reported that the esc is shutting down to early due to overheat protection, just try the
latest firmware and that problem will most likely be gone.
Latest firmware for 80A ESC as far as I know is «AHKA 2111 12MB 8002» from January 2012.
My conclusion, Turnigy Super Brain 80A esc is a fantastic and problem-free ESC as long as you dont trust
the logger, or atleast change the config.ini file to something that represent the reality more accurate.
This document was written 30.11.2012 by a norwegian dude, I hope my english is readable.
Alot of this information are taken from various forums (most from rcgroups).
You can PM me at http://www.rcgroups.com, my name is Kiwz.