145688492X1573078X38

TGY-AEV01 I-Bus!

I-Bus receiver, can connect 4 modules with 16 channels in serial at most. Button K1 and

K4 correspond to C1 and C4 respectively.!

Operation Instruction:!

" 1." TGY-AEV01 i-Bus The “IN” port oftTGY-AEV01 receiver corresponds to “out” port

of receiver.!

" 2." TGY-AEV01 i-bus The “out” port of TGY-AEV01 receiver is used to connect post

level TGY-AEV-01 receiver.!

" 3." Insert the bus receiver to receiver , and then switch on the matched transmitter

and receiver . The LED will be on.!

" 4." Select main menu of receiver setup to enter the interface of servo setup.!

" 5." Select channel which need to be expanded, meanwhile LED of bus receiver is oﬀ.!

" 6." Push relevant channel button by plastic needle of matching line. The setup is

successful if LED Flashes automatically.!

" 7." Insert servo to check.!

" 8." Set up 4 channels of bus receiver as above steps.!

" 9." just connect a new bus receiver with “out”port of ﬁrst stage bus receiver if more

channel needed. Set up the new one as above steps.!

PAGE 1
TGY-AEV01 I-Bus I-Bus receiver, can connect 4 modules with 16 channels in serial at most. Button K1 and K4 correspond to C1 and C4 respectively. Operation Instruction: 1. TGY-AEV01 i-Bus The “IN” port oftTGY-AEV01 receiver corresponds to “out” port of receiver. 2. TGY-AEV01 i-bus The “out” port of TGY-AEV01 receiver is used to connect post level TGY-AEV-01 receiver. 3. Insert the bus receiver to receiver , and then switch on the matched transmitter and receiver . The LED will be on. 4.