Manual

Mobi 360 6
Mobi 360 Setup
The Mobi 360 and digital pen are delivered partially charged to allow you to use these items immediately after unpacking the
box. However, it is recommended to charge these items for approximately eight hours before beginning normal use.
This section covers the following topics:
Pairing the Mobi 360 with the Receiver
Calibrating the Mobi 360 Touchscreen
Changing the Language
Adjusting the Brightness
Calibrating the DualBoard™
Updating Firmware
Pairing the Mobi 360 with the Receiver
The Mobi 360 connects with the Insight 360 software through the wireless Mobi 360 receiver. The receiver is a USB device
stored in the charging stand or on the backside of the Mobi 360.
The Mobi 360 is paired with its Mobi 360 receiver at the factory. This pairing is confirmed the first time the Mobi 360 is turned
on. The first time the Mobi 360 is turned on, it attempts to connect automatically with its receiver. If Mobi 360 cannot connect to
its receiver, you can manually pair the device.
NOTE
You can check the connection status of both devices from Device Management in My Settings on the
Insight 360 software.
How to pair the Mobi 360 with the receiver...
1
Turn on the classroom computer on which the Insight 360 software is installed.
2
Insert the Mobi 360 receiver into a USB port.
NOTE
If a USB hub is needed, ensure that a powered USB hub is used.
3
Turn on the Mobi 360 by pressing the blue power button on the top of the unit.
The message Please wait while a connection to Insight 360 is being established is displayed on the Mobi 360 screen.
4
When the message, Ensure the Mobi 360 Receiver is displayed, confirm the Mobi 360 receiver has been inserted into a
working USB port.
5
Press and release the blue button on the Mobi 360 receiver while the receiver is still inserted into the USB port on the
computer.
6
Tap Continue on the Mobi 360.
The message Please wait while a connection to Insight is being established shows on the Mobi 360 screen. When the
Mobi 360pairs with its receiver, the Teach Class screen is displayed on the Mobi 360.
How to pair the Mobi 360 with the receiver manually...
1
You can pair the Mobi 360 with its receiver manually if they do not pair automatically or if the Mobi 360 receiver has been
replaced with a new one. Turn on the classroom computer on which the Insight 360 software is installed.
2
Insert the Mobi 360 receiver into a USB port on the classroom computer.
turningtechnologies.com/user-guides