Owner's manual

______________________________________________________________ Response User’s Guide
15 | Page
1. Select Setup My Hardware from the main screen.
2. Right-click the Response Receiver icon, then select Properties.
3. Click the Configure Clickers tab.
4. Choose Loaner from the Clicker Type drop down menu.
5. Click on the Setup button to display the Feedback
instructions.
6. Turn on Student Response Pad.
7. Input the number or letter (the channel) that
appears at the end of the line in angled brackets.
Ex: <3>
8. Once you see Loaner on the 2
nd
line, press the
arrow key to join.
When seeing Join ID followed by a number, this means that
you have successfully configured your Student Response
Pad.
Instructor Configuration
A PRS RF Response Pad configured as an Instructor Student Response Pad is used to remotely
control a Response session. For example, an Instructor Student Response Pad allows you to
start and stop a question from anywhere in the classroom.
1. Select Setup My Hardware from the main screen.
2. Right-click the Response Receiver icon, then select Properties.
3. Click the Configure Clickers tab.
4. Choose the Clicker Type Instructor from the drop down menu.
5. Click on the Setup button to display the Feedback instructions.
6. Turn on your Student Response Pad.
7. Input the number or letter (the channel) that appears at the end of the line in
angled brackets. Ex: <3> The channel may vary on each setup.
8. Once you see Instructor on the 2
nd
line, press the green arrow key to join.
9. If you see Join ID followed by a number it means that you have successfully
configured your Student Response Pad.