User Manual


Hardware
TheTurningmodelRRAP‐01enclosureexposestwoconnectorsandthreeLEDs.
Connectors
TheRJ‐45connectorisforconnectingtoaWideAreaNetwork(WAN)andoptionallypoweringtheunit.
TheeRJ‐45connectorsupports10/100/1000Base‐TEthernet.TheRJ‐45connectoralsosupportsPower
overEthernet(POE).IfthenetworkwiringsupportsPOEthisistheonlyconnectionneeded.
Apower
connectorjackisalsoprovidedtosupportinstallationswithoutPOEwiring.Awalltransformer
stylepowersupplyisincludedwiththeunit.
LEDS
FourLEDindicatetheunit’sstatus.Theyare:
• Green UnitStatus
o Blinkstwiceeverysecond
• Red UnitStatus
o Onuntilunitbootsorafteranunrecoverableerrorhasoccurred
• Blue Wi‐FiStatus
o OnwhentheAccessPointWi‐Fiisrunning
• Yellow Ethernet
Status
o OnwhentheEthernetportisconnectedandrunning
InternallyAccessedHardware
InsidetheRRAP‐01enclosurearethefollowinghardware:
• AmicroSDconnectorwith8GbmicroSDcard
• 2RedLEDindicatingread/writeaccesstothemicroSDslot
• ASystemResetbutton
o resetstheunitsprocessorandhardware
• AUserbutton–resetstheUser
Configurationtofactorydefaults
o Mustbeheldfor5seconds