Instruction Manual

WorkSpace for Java 9
IMPORTANT
You have two minutes to press the activation button.
When the two devices have been successfully paired, the blue button on the Mobi receiver will stop blinking and remain
a solid blue until one of the following three instances occur:
l the Mobi receiver is removed from the computer
l the Mobi is turned off
l the computer is turned off
Pairing the device is a one-time operation.
Setting Up the DualBoard via USB
The Turning Technologies Device Manager must be installed on your computer prior to using the DualBoard. Device Manager
is automatically installed with the following software: WorkSpace, CPS, Response and Flow.
1
Connect the AC/DC power adapter to the controller box.
2
Plug the opposite end of the AC/DC power adapter into a wall outlet.
3
Connect the USB cable to the DualBoard controller box.
4
Plug the opposite end of the USB cable into an available USB port on your computer.
5
Click the Power switch to the On position.
NOTE
The AC/DC power adapter is only used to charge the electronic pens.
Setting Up the DualBoard via Wireless Kit
The Turning Technologies Device Manager must be installed on your computer prior to using the DualBoard. Device Manager
is automatically installed with the following software: WorkSpace, CPS, Response and Flow.
An RF (Radio Frequency) receiver plugs into a USB port on your computer or a powered USB Hub. A second receiver is
connected to the DualBoard controller box via USB cable. The receiver is seated in a holster that slips over the frame at the top
of the board.
The RF receiver works best when it is not plugged into a computer that is under a podium or a desk. If necessary, use a
powered USB extension cable to remove the RF receiver from under furniture that may shield the RF signal.
1
Connect the AC/DC power adapter to the DualBoard controller box.
2
Plug the opposite end of the AC/DC power adapter into a wall outlet.
3
Plug the end of the USB cable (RJ12) into the DualBoard controller box located on the back of the board. The
controller box is located on the bottom left of the board, if the board has already been hung up.
4
Slide the RF COM plastic grey holster over the board’s frame at the top of the DualBoard.
5
Seat the receiver into the plastic grey holster.
6
Click the Power switch to the On position.
7
Plug the RF receiver into an available USB port on your computer.
8
Press the pairing button on the receiver.
einstruction.com/workspace-overview