Owner's Manual

5
6
XP300 Transmitter
1
2
3
4
Power/Link LED: When the transmitter is powered on and
communicating with the headset, this LED will be on solid. When
the headset is turned off, the LED will turn off. A slowly pulsing LED
indicates that the transmitter can’t communicate with the headset.
This could happen when the headset is out of range, turned off or not
paired with the transmitter. (see pg 6)
Game Audio Input Jack
Insert the 3.5mm end of the included RCA Splitter Cable into this jack.
Auxiliary Input Jack: Provides a 3.5mm input for digital music players
or additional audio sources. (3.5mm cable sold separately)
Pairing Button: Press and hold to activate pairing mode. (See pg. 6)
1
2 3 4
Using the Transmitter
Transmitter Range
The transmitter sends game audio from your Xbox 360
®
to the headset
via digital radio frequency (RF) signal, so a direct line of sight is not
required. When you’re out of range, you may hear popping or clicking
sounds if the headset loses the RF signal. For best performance, place
the transmitter in an open area that is unobstructed by objects that
might absorb RF signals from the internal antenna. Avoid placing it on
a metal surface, such as the top of a home theater A/V receiver.
Pairing the Headset and Transmitter
The headset and transmitter in this package are “paired”, which means they’re synchronized to ensure they work together. When
the headset and transmitter are communicating, the POWER LED on the the transmitter will be on solid. If this LED is slowly pulsing
instead, it means the transmitter can’t communicate with the headset. This could happen when the headset is out of range, not turned
on or not paired with the transmitter. If the LED is slowly pulsing when the headset is on and within range, then they might need to be
“paired” as described below:
NOTE: Only one headset can be paired with the transmitter. If you pair two headsets with the same transmitter, they’ll interfere with each other
as they compete for the transmitter RF signal. This will cause one headset to shut off. So don’t try to pair two headsets with the same transmitter!
2 feet
Maintain a distance of at least
2 feet between the headset and
transmitter when pairing.
Optimum range: within 30 ft.
1. Make sure the headset and transmitter are turned off and
they are at least 2 feet away from each other.
2. Power on the transmitter by connecting it to a free USB
port on your gaming console. Then press and hold the
PAIR button on the transmitter. The transmitter LED will
begin to flash rapidly, then release the PAIR button.
3. Press and hold the headset POWER button for about 6
seconds until the LED begins to flash rapidly, then release
the button.
4. Wait for the headset and transmitter to pair. This process
could take up to 30 seconds.
If pairing is successful, the LED on the transmitter should be
on solid and the headset LED should be flashing about once
per second, indicating that the units are paired.
If pairing fails, repeat steps 1-4. It may take up to 5 attempts
to pair successfully.